The sofa consists of 5 parts: left side, right side, backrest, seat and crossbar. Building up is very simple (10-15 minutes). Construction with pin-hole connections. Mounting instructions: Lay one side flat on the floor so that the holes in which the seat and backrest should be placed are visible. Insert the backrest and crossbar into the side holes and, if necessary, gently tap them with a spool and hammer. Now apply the seat by pressing the seat pins into the holes in the backrest and crossbar. Note that the labels applied to the various components are opposite each other. Take the second side and attach it. If necessary, knock on the door with a spool and hammer. In each side you will see 6 holes (2 at the front, 4 at the back) where the supplied dents need to be inserted. Please note that it is not possible either to be completely absorbed. The dowels are always longer than necessary. You can cut off the part that still protrudes, preferably with a saw blade from a hacksaw. Then connect the seat with the sides using the 4 supplied screws.

Do you want your bank not to age? Then use teak exterior from rubio monocoat. 100ml is sufficient for the entire bank.

Would you rather receive the sofa fully assembled? This can be done at a small additional cost.
Matching seat cushion also available in gray / anthracite.