€149,00
€169,00 Incl. taxThe sofa consists of 5 parts: left side, right side, backrest, seat and crossbar. Building up is very easy (10-15 minutes). Construction with pin-hole connections. Assembly instructions: Lay one side flat on the floor so that the holes in which the seat and backrest must go are visible. Insert the backrest and the crossbar into the holes on the side and tap them gently if necessary with a spool and hammer. Now install the seat by pressing the pins of the seat into the holes of the backrest and crossbar. Make sure that the labels affixed to the various components face each other. Take the second side and attach it. If necessary, knock with a spool and hammer. In each side you will see 6 holes (2 at the front, 4 at the back) in which the supplied dowels must be placed. Note: it is not possible, nor is it the intention that these are completely beaten. The dowels are always longer than necessary. You can cut off the part that still protrudes, preferably with a hacksaw saw blade. Then connect the seat to the sides using the 4 screws supplied.
Do you not want to let your bank age? Then use teak exterior from rubio monocoat. 100ml is sufficient for the entire bank.
Would you rather receive the sofa fully assembled? This is possible at a small additional cost.
Matching seat cushion also available in gray / anthracite.
Dimensions W x H x D: |
€149,00
€169,00